Yayıncı "INST ZA KOVINSKE MATERIALE I IN TEHNOLOGIE" için listeleme
Toplam kayıt 5, listelenen: 1-5
-
2D NUMERIC SIMULATION OF SERRATED-CHIP FORMATION IN ORTHOGONAL CUTTING OF AISI316H STAINLESS STEEL
(INST ZA KOVINSKE MATERIALE I IN TEHNOLOGIE, 2017)Low thermal conductivity, high strength, high ductility and high work-hardening tendency of austenitic stainless steels are the main factors that make their machinability difficult. 'Phis study investigates the influence ... -
EFFECTS OF CUTTING PARAMETERS AND TOOL-PATH STRATEGIES ON TOOL ACCELERATION IN BALL-END MILLING
(INST ZA KOVINSKE MATERIALE I IN TEHNOLOGIE, 2017)The determination of the cutting-parameter values that cause increases in vibration values is important to minimize the errors that can occur. Thus, the first aim of this study was to investigate the optimum cutting-parameter ... -
INVESTIGATING THE EFFECTS OF CUTTING PARAMETERS ON THE BUILT-UP-LAYER AND BUILT-UP-EDGE FORMATION DURING THE MACHINING OF AISI 310 AUSTENITIC STAINLESS STEELS
(INST ZA KOVINSKE MATERIALE I IN TEHNOLOGIE, 2015)This study experimentally investigated the effects of machining parameters on the built-up-layer (BUL) and built-up-edge (BUE) formation and the wear behavior of cutting tools during the machining of the AISI 310 austenitic ... -
INVESTIGATION OF THE GEOMETRICAL ACCURACY AND THICKNESS DISTRIBUTION USING 3D LASER SCANNING OF AA2024-T3 SHEETS FORMED BY SPIF
(INST ZA KOVINSKE MATERIALE I IN TEHNOLOGIE, 2017)Incremental sheet forming (ISF) is developed in order to meet the increasing demand for sheet metal forming and because it is a more economical method. First of all, this method gains attention become it is a die-less ... -
OPTIMISING THE EFFECT OF CUTTING PARAMETERS ON THE AVERAGE SURFACE ROUGHNESS IN A TURNING PROCESS WITH THE TAGUCHI METHOD
(INST ZA KOVINSKE MATERIALE I IN TEHNOLOGIE, 2018)In this study, the AISI 1040 steel was exposed to a turning process. The experiment list was created with the Taguchi L-16 experiment design based on the cutting speed, feed rate and depth of cut. The turning experiments ...